BGP OSPF Questions: Difference between revisions

* We need to enable MLS QOS,FOr switches we can do both the inbound and outbound queing ,whenever traffic hit the ingress port switch will first do cleassifcation/marking based on port configration ,then it goes to policer if configured to trasmit/remark/drop the traffic ,then it goes to inbound queing before it is transmitted .on swicthes when we enable MLS QOS and there is no trust boundary configured it will rewrite the traffic to ZERO.ss

* Ingress/EGRess -Packets are mapped to queue bases on DSCP/COS value.

* If the port is an access port or Layer 3 port, you need to configure the mls qos trust dscp command. You cannot use the mls qos trust cos command because the frame from the access port or Layer 3 port does not contain dot1q or ISL tag. CoS bits are present in the dot1q or ISL frame only.

* If the port is trunk port, you can configure either the mls qos trust cos or mls qos trust dscp command. The dscp-cos map table is used to calculate the CoS value if the port is configured to trust DSCP. Similarly, the cos-dscp map table is used to calculate the DSCP value if the port is configured to trust CoS.

* By default, the PC sends data untagged. Untagged traffic from the device attached to the Cisco IP Phone passes through the phone unchanged, regardless of the trust state of the access port on the phone. The phone sends dot1q tagged frames with voice VLAN ID 20. Therefore, if you configure the port with the mls qos trust cos command, it trusts the CoS values of the frames from the phone (tagged frames) and sets the CoS value of the frames (untagged) from the PC to 0. After that, the CoS-DSCP map table sets the DSCP value of the packet inside the frame to 0 because the CoS-DSCP map table has DSCP value 0 for the CoS value 0. * If the packets from the PC have any specific DSCP value, that value will be reset to 0. If you configure the mls qos cos 3 command on the port, it sets the CoS value of all the frames from the PC to 3 and does not alter the CoS value of the frames from the phone.

* Queing for 6500 -

Receive queue -1p1q4t -One priority queue and 1 standard queue wth 4 threshold .

Transmit queue -1p3q4t ,1p7q8